Setting the cutting height is the same on all M A Series III bench top clickers.

    Adjustment:-
               

                Place the die you plan to use on
                the cutting board without any material.
                              
                (A) Ease the handle forward until
                the head is resting on the Die (do not apply any pressure at this
                time).
                               
                (B) Lift handle. Adjust height
                control clockwise or anti-clockwise.
               
               
                (C) Ease handle
                forward.
               
               
                Repeat steps A B C until handle
                (in the down position) sits about 3-4 cm.  from the press
                head buffer (white).
               
               
                This should be satisfactory for
                most materials.
               
   
                Some small further adjustments may
                be necessary depending on the size of the knife and toughness of the
                material being cut.